[scribus] perfect bound 3mm gutter question/problem?

ale rimoldi ale.comp_06 at xox.ch
Thu Apr 26 06:07:56 UTC 2012

hi richard

> Thanks for your reply and I believe you understand me correctly. The
> 6mm is LSI recommendations for bleed, although the actual cutting
> error/drift over edge is expected to be 2mm. The 3mm inside glueing
> area now sounds like a potential problem.
> If I, in turn, understand you correctly, my pages will have 3mm
> 'lost' from their inside edges, because of the glue. If this is the
> case, then I should probably have realized this before I started.
> Every page will be visibly 3mm thinner than planned, and offset
> slightly.

no, not really... if i understand you correctly. you use the margins as
you want to see them, and set the bleeds in file > document setup to
get the extra margins.


More information about the scribus mailing list