[scribus] Page numbers blanking out

[Gregory Pittman]

On 02/05/2018 09:51 AM, Mark Cornwell wrote:
> Hello,
> 
>  
> 
> I'm new to Scribus. I've been designing a layout for a photo book with text.
> 
>  
> 
> I've put in lots of pages and images/text etc. Then I went to create a TOC.
> 
>  
> 
> I also spotted the Ctrl+Alt+Shift+P to add a page number to a page and to
> add a text box with that in it on the master.
> 
> I also found out how to set up page numbering to start after the TOC via
> Document Setup>Sections.
> 
>  
> 
> So far so good.
> 
>  
> 
> My document now has three pages with no page numbering (intro/TOC) and then
> starts with page number 1 on page layout 4.
> 
>  
> 
> That's all working.
> 
>  
> 
> What I can't work out is that when I get to page 10 the page numbers just go
> blank again.
> 
>  
> 
> My sections have:
> 
> Name 0, Shown tick, From 1, To 3, Style None, Start 1.
> 
> Name 1, Shown tick, From 4, To 57, Style 1,2,3., Start 1.
> 
>  
> 
> I've not "stopped" the section at page 10.
> 
>  
> 
> I have tried applying the master again to all pages. That didn't make any
> difference. All I see on pages 10 and beyond in Scribus is a rectangle with
> a small box with a cross in it to the bottom right. If I create a PDF via
> Export then it leaves the page numbers empty on pages 10 and beyond.
> 
>  
> 
> Just in case it is relevant - pages 34 and onwards are currently blank.
> 
>  
> 
> Any bright ideas, please?
> 

Have you checked to make sure you have applied the master page to 10 and
beyond?

Greg