[Scribus] speed problem once more

kuba kuba
Tue Apr 19 00:00:37 CEST 2005


Dnia pi?tek, 15 kwietnia 2005 09:11, Uwe Fechner napisa?(a):
> Hello,

hello!

> just to make shure, there is no hardware/ configuration issue:
>
> What is the output of the following command (as root):
>
> hdparm -t /dev/hda3
>
> I get:
> /dev/hda3:
> Timing buffered disk reads:  162 MB in  3.04 seconds =  53.25 MB/sec
> (60 GB Harddisk, 7200 rpm)
>

/dev/sda8:
 Timing buffered disk reads:  154 MB in  3.01 seconds =  51.14 MB/sec
BLKFLSBUF failed: Operation not supported
HDIO_DRIVE_CMD(null) (wait for flush complete) failed: Operation not supported

heh?

> Are you shure, more than 10% of your diskspace is free?

yep

> What gives:
> free
> as result?

             total       used       free     shared    buffers     cached
Mem:       1035964    1029452       6512          0     152352     497672
-/+ buffers/cache:     379428     656536
Swap:      2546260        160    2546100

> If you work with a large amount of text, you should edit it using the
> integrated
> text editor.
> There is a known speed issue if you edit text in the WYSIWYG mode, it
> will be improved
> a little bit in the 1.3 version of scribus.

yes, i've noticed. but it's also just displaying that is slow. i was even 
begining to think that it's not that bad and i can live with it, but than 
after few minutes back to pagemaker... it's uncomparable.

and why it takes several seconds for pdfs (just text and picture) to display 
in adobe...? while similar ones show instantly. i don't see how it could be 
connected to hardware.

anyway, thank you for your suggestions!

ps. i also tried fedora yesterday and it's the same. please, tell me that it 
is not just how this program works...

regards
kuba




More information about the scribus mailing list