[scribus] [Fwd: Using Scribus for book-signature layout]

Gregory Pittman gregp_ky at yahoo.com
Wed Oct 12 15:01:22 UTC 2011


On 10/11/2011 01:11 AM, Peter Linnell wrote:
> ---
>
> Dear Sir or Madam,
>
> In looking for page-layout software within the price range of my
> non-existent budget, I found and downloaded Scribus and GhostWriter.
>
> I have already laid out a book using Publish 2007, all seventy-two pages on
> nineteen double-sided folios.  A copy of the master has been cut and is
> ready to bind.
>
> However, I would like to do the lay-out in in three-sheet signatures of
> twelve pages, since glueing may prove better with folds than with single
> edges.
>
> The page number lay-out for the first signature should be:
>
> Sheet 1 of Signature 1, recto, left to right:  Page 12&  Page 01
> Sheet 1 of Signature 1, verso, left to right:  Page 02&  Page 11
>
> Sheet 2 of Signature 1, recto, left to right:  Page 10&  Page 03
> Sheet 2 of Signature 1, verso, left to right:  Page 04&  Page 09
>
> Sheet 3 of Signature 1, recto, left to right:  Page 08&  Page 05
> Sheet 3 of Signature 1, verso, left to right, Page 06&  Page 07
>
> Page 01 is blank.
> Page 02 is blank.
> Page 03 is the Title Page (not marked with page number).
> Page 04 is the copyright page (not marked with page number.
> Page 05 is the Dedication Page (no page number or title banner).
> Page 06 is the blank reverse of the Dedication Page.
> Page 07 is the Acknowledgments Page (no page number or title banner).
> Page 08 is the blank reverse of the Acknowledgments Page.
> Page 09 is the Table of Contents (page ix in the bottom right-hand corner,
> in italics).
> Page 10 is the blank reverse of the Table of Contents.
> Page 11 is page 1 of the text body (header banner has the title on the
> outside and the page number on the inside.
> Page 12 is the blank reverse of the Introduction.
>
> Page 13 would be on the right end of the recto of Sheet 4, Signature 2
>
> The book is 5.25 inches wide with half-inch margins all the way around
> except for the gutter, which is three-quarters of an inch wide.  It is 8.5
> inches high and about three-eighths of an inch thick.  The dimensions were
> determined by my itsy-bitsy budget and the need to use letter-sized
> photographic paper for the cover.
>
> Can Scribus be used to accomplish this?
>
> Sincerely,
>
> Christine Wolfe, author
> the,ubiquitous.wolfe at gmail.com
>
>
Hi Christine,

Scribus can certainly be used for the necessary layout.
The business of printing particular layout pages on particular print 
pages in specific places in imposition. Scribus cannot do imposition 
internally.

Here are some references:
http://wiki.scribus.net/canvas/Category:Contents#Imposition

If you are using a commercial printer, they may be willing and even 
prefer to do the imposition for you. You would still want to do your 
Scribus work with left and right pages, inserting blanks where needed, 
to make the printer's job easier.

Greg




More information about the scribus mailing list